Use the laminfo command (similar to Open MPI's ompi_info command --
hmm... how did that happen? ;-) ) to see what SSI modules are
available in your LAM installation.
If you didn't get tm support in your LAM installation, you can re-
install with the --with-tm switch to configure. See the LAM/MPI
installation guide for more details:
http://www.lam-mpi.org/using/docs/
On Oct 18, 2007, at 1:53 PM, Guilherme Menegon Arantes wrote:
>
> Hi list,
>
> I have not been able to use the tm module within my current LAM
> installation. LAM works fine with the SSI boot rsh for interactive
> jobs
> and for batch jobs with Torque, but a Torque job such as:
>
> #!/bin/sh
> #PBS -l nodes=4
> ###
> lamboot
> mpirun N xhpl
> lamhalt
>
> runs only in one node (the master). If I force the tm module with:
>
> lamboot -ssi boot tm
>
> I get "The boot module named "tm" could not be found.". I am using:
> LAM 7.1.2/MPI 2 C++/ROMIO
> TORQUE 2.1.2 (with their simple pbs_sched scheduler)
> both installed from Debian pre-compiled binaries.
>
> How can I check if tm support was compiled/is working within LAM? And
> within Torque? Is this a Torque issue (so I should go and bother their
> users instead)? Any pointers are welcome since a search was not very
> helpful.
>
> Thanks in advance,
>
> G
>
> --
>
> Guilherme Menegon Arantes, PhD São Paulo, Brasil
> ______________________________________________________
>
> _______________________________________________
> This list is archived at http://www.lam-mpi.org/MailArchives/lam/
--
Jeff Squyres
Cisco Systems
|
