Salut Clement
-check against which lam / mpi Version your LS Dyna was built
( ldd mpp_ls971..... )
-then for a start do a "manual" lamboot without batch system
locally on a two CPU node
if the lam/mpi binary connects well to lam, repeat those steps for two
different nodes with real network communication
to give feedback for debugging: We have every existing dyna Version
running well with lam / mpi
The only issues are:
-use the lam/mpi against which dyna was built
-integrate the lam / mpi start into the batch system
( there you have different choices )
if you have problems getting started, do in a bazch script exactly
the same steps you would do manually
hth
Micha
--
Vorstand/Board of Management:
Dr. Bernd Finkbeiner, Dr. Florian Geyer,
Dr. Roland Niemeier, Dr. Arno Steitz, Dr. Ingrid Zech
Vorsitzender des Aufsichtsrats/
Chairman of the Supervisory Board:
Prof. Dr. Hanns Ruder
Sitz/Registered Office: Tuebingen
Registergericht/Registration Court: Stuttgart
Registernummer/Commercial Register No.: HRB 382196
|
