It looks like your 7.1.1 build does not contain the blcr checkpoint/
restart components. I can't tell you why this would be without
seeing the entirety of the config.log files - the first couple lines
don't really tell me all that much. They are fairly large files, so
please compress them and send as attachments.
Brian
On Dec 28, 2005, at 8:26 PM, Liu Xuezhao wrote:
> The blcr module had been build already, and the lam-7.0.6 can load
> it correctly, but lam-7.1.1 can not.
> The config.log files of 7.0.6 and 7.1.1 are the same also:
> ---------------
> lxz_at_ganode004:~/src> head lam-7.0.6/share/ssi/crlam/blcr/config.log
> This file contains any messages produced by compilers while
> running configure, to aid debugging if configure makes a mistake.
>
> It was created by configure, which was
> generated by GNU Autoconf 2.59. Invocation command line was
>
> $ ./configure --with-blcr=/home/lxz/opt/blcr --with-cr-file-dir=/
> home/lxz/tmp --with-rpi=crtcp --prefix=/home/lxz/opt/lam-7.0.6 --
> with-rsh=ssh -x --cache-file=/dev/null --srcdir=.
>
> lxz_at_ganode004:~/src> head lam-7.1.1/share/ssi/crlam/blcr/config.log
> This file contains any messages produced by compilers while
> running configure, to aid debugging if configure makes a mistake.
>
> It was created by configure, which was
> generated by GNU Autoconf 2.59. Invocation command line was
>
> $ ./configure --with-blcr=/home/lxz/opt/blcr --with-cr-file-dir=/
> home/lxz/tmp --with-rpi=crtcp --prefix=/home/lxz/opt/lam-7.1.1-
> withblcr --with-rsh=ssh -x --cache-file=/dev/null --srcdir=.
> --------------
> When executing lam-7.0.6's laminfo, it prints:
> SSI cr: blcr (Module v1.0.1)
> But lam-7.1.1's laminfo prints:
> SSI cr: self (API v1.0, Module v1.0)
>
>
>
> ======= 2005-12-28 12:00:00 ：=======
>> From: Brian Barrett <brbarret_at_[hidden]>
>> To: General LAM/MPI mailing list <lam_at_[hidden]>
>> Subject: Re: LAM: Can't restart MPI applications after the LAM RTE
>> is reboot
>> Date: Wed28 Dec 2005 00:08:14 -0500
>>
>> It sounds like you might not have the blcr components properly
>> built. Can you make sure the components are actually loaded by
>> looking at the output of laminfo? If there is not a blcr cr
>> component listed, then there is no blcr support in your build. At
>> that point, it would be useful to look at the output of configure
>> and/
>> or the config.log from the top source directory and the one from
>> share/ssi/crlam/blcr/.
>>
>>
>> Brian
>>
> ===================================
>
>
>
>
> _______________________________________________
> This list is archived at http://www.lam-mpi.org/MailArchives/lam/
|
