Hello,
I'm getting the following screen output after my simulation has not
converged a few times (I haven't counted how many times it takes).
lamboot works fine, along with mpirun, and so forth. But when my
simulation ends a few times due to the solution not converging,
eventually mpirun will not work. To remedy this, I need to reboot my
G5, which is something I'd like to avoid. Any ideas?
Thanks,
Rich Regueiro
------------------------------------------------------------------------
-----
The selected RPI failed to initialize during MPI_INIT. This is a
fatal error; I must abort.
This occurred on host raregue-g5.ran.sandia.gov (n0).
The PID of failed process was 27659 (MPI_COMM_WORLD rank: 0)
------------------------------------------------------------------------
-----
------------------------------------------------------------------------
-----
One of the processes started by mpirun has exited with a nonzero exit
code. This typically indicates that the process finished in error.
If your process did not finish in error, be sure to include a "return
0" or "exit(0)" in your C code before exiting the application.
PID 27660 failed on node n0 (127.0.0.1) with exit status 1.
------------------------------------------------------------------------
-----
|
