I guess the fact that a few other sites have it running indicates I
have a
deployment problem. I will dig a little deeper and try to figure it
out.
Thanks for the feedback.
-geoff
On Sep 2, 2004, at 12:48 AM, etienne gondet wrote:
>
>
> Hello,
>
> we recently installed torque on an opteron system and sucessfully
> installed lam7.0.6 in 64 bits mode with pgi 5.1 using the tm interface
> and it works fine.
>
> The only things are :
> with pgi5.1 I could use pgf90 but not pgcc for reasons already
> listed in the lam archive so I used gcc in 64 bits
> but appenrtly with pgi5.2 you should compile all lam
> 7.0.6 with pgcc
>
> I compile torque in 32 bits and didn't try 64 bits modes.
>
>
> Etienne Gondet, GIP MERCATOR-Ocean system team.
>
> Geoff Galitz a écrit:
>
>>
>>
>> Hello,
>>
>>
>> After migrating our OpenPBS system to Torque (based on OpenPBS), the
>> tm interface appears to have stopped working for us. Is anyone else
>> using this configuration? This is LAM 7.0.2 compiled with the
>> Portland Group Compilers.
>>
>> -geoff
>>
>>
>>
>>
>> http://www.galitz.org
>>
>> _______________________________________________
>> This list is archived at http://www.lam-mpi.org/MailArchives/lam/
>>
>>
>
>
> _______________________________________________
> This list is archived at http://www.lam-mpi.org/MailArchives/lam/
|
