Hello,
I suggest that you should look at CISCO documentation, which may contain
such kind of information.
Hope this helps.
Amey S. Dharurkar
----------------------------------------------------------
Graduate Student, Indiana University
Ph. (812)331-8203
On Wed, 8 Oct 2003, Raheel Ahmad wrote:
> Hello,
> This may seem like a trivial question but I could not get a convincing
> answer any where so I had to ask. I have a cluster with all the nodes
> directly connected to a Cisco Catalyst 3500 switch. Everything runs fine.
> However, how do I know what topology the switch itself is using? Basically I
> want to test the cluster with different topoligies like ring, mesh,
> hypercube. Is there anyway I could do that using the switch?
> Thank you.
>
> _________________________________________________________________
> High-speed Internet access as low as $29.95/month (depending on the local
> service providers in your area). Click here. https://broadband.msn.com
>
> _______________________________________________
> This list is archived at http://www.lam-mpi.org/MailArchives/lam/
>
|
