Hello,
This may seem like a trivial question but I could not get a convincing
answer any where so I had to ask. I have a cluster with all the nodes
directly connected to a Cisco Catalyst 3500 switch. Everything runs fine.
However, how do I know what topology the switch itself is using? Basically I
want to test the cluster with different topoligies like ring, mesh,
hypercube. Is there anyway I could do that using the switch?
Thank you.
_________________________________________________________________
High-speed Internet access as low as $29.95/month (depending on the local
service providers in your area). Click here. https://broadband.msn.com
|
