Sukma,
This is not Jeff or LAM's problem. Please don't cross-post like this.
I'll send a separate email discussing the problem just to our list.
Rob
On Mon, 4 Aug 2003, sukma kayangan wrote:
> Dear All...
> I have done the compilation as the suggested procedure and still getting the same error message while trying to run the pvfs-test tool...here are the details :
> 1. I downloaded the latest cvs source "lam-7.1a1cvs20030804.tar.gz" (is this the correct filename ? ), extracted it and then the first step of LAM-MPI compilation would be :
>
> shell_at_LAM-MPI/root/directory # ./configure --with-romio-flags=-file_system=pvfs+nfs --with-romio-libs="-L/path/to/pvfs/install -lpvfs"
>
> of course then I did the "make" and "make install" ...
>
> ==> Do i need to invoke another "./configure" on any sub-directory like "romio"...?
>
> 2. After the successful LAM-MPI compilation, then I compile the pvfs-test.c, it is the source code of the pvfs-test tool :
>
> shell@/usr/src/pvfs/utils# mpicc -D__USE_MPI__ -I../include pvfs-test.c -L../lib -lpvfs -o pvfs-test
>
> ==> Are both of procedures above correct...?
>
> 3. Then I tried to start the LAM-MPI service and ran the pvfs-test over the file "/pvfs/uyab" (/pvfs is the pvfs mount point)
>
> [BayuS_at_Sukmabayu7 /]$ lamboot
>
> LAM 7.0/MPI 2 C++/ROMIO - Indiana University
>
> [BayuS_at_Sukmabayu7 /]$
>
> [BayuS_at_Sukmabayu7 /]$ pvfs-test /pvfs/uyab
> # Using native pvfs calls.
> node 0, open error: No such file or directory
> [BayuS_at_Sukmabayu7 /]$
>
> ==> the error message above is the same error message I've faced since the beginning of the measurement trial...
>
> Herewith I attached the pvfs-test.c so you can trace the problem...
> Please give me some supporting response due to this problem...
> thank you very muc at advance...
> a very best regards...
> sukma
>
>
>
> Note: forwarded message attached.
>
>
> ---------------------------------
> Do you Yahoo!?
> Yahoo! SiteBuilder - Free, easy-to-use web site design software
|
